What do you get when you combine high quality materials, state-of-the-art engineering, and a liberal dose of Rockford Fosgate's famous bass fanaticism? The answer: Power Stage 2 subwoofers. Ideally suited for use with Power Series amps, these woofers handle incredible power levels — up to 2,000 watts peak.
The mind-blowing 304-ounce magnet structure is triple stacked, and the huge 4" voice coils were born to handle big power. The aluminum parabolic cone with its high-excursion rubber surround hits quickly and accurately. Spider venting keeps the woofer cool even when you run it long and hard.
The T215D2 15" subwoofer works best in a vented enclosure. The dual 2-ohm design lets you wire for high output or a multiple woofer setup.
Note: If you are wiring this DVC sub for lower impedance, make sure that your amp is compatible. Most car amplifiers are stable down to 2 ohms in standard mode, or 4 ohms in bridged operation.
Details:
15" subwoofer with dual 2-ohm voice coils
aluminum parabolic woofer cone with rubber surround
cast aluminum basket
power range: 150-1,000 watts RMS (500 watts per voice coil)
"Kicker ZX300.1 is the perfect car stereo amplifier for those who are fond of bass. This amplifier is designed with high-end amplification to set standards for a powerful sound and a unique look would make your amplifier stand apart from the various other amplifiers. The Kicker ZX300.1 mono subwoofer would control your subs with nearly 300 watts of power. This unit does not have a peak power rating and you can ensure that the amplifiers CEA-2006 compliant rating would mirror a true measure of its capabilities. Similar to all the kicker amplifiers the Kicker ZX300.1 is also designed with a high quality internal component to offer you a reliable performance. The Kicker ZX300.1 features an in built low pass filter that helps in removing high frequency that is generated by the amplifiers output, so that you get the most from your subwoofers. Apart from this, there is a subsonic filter that eliminates the intense low bass that usually hampers the system efficiency. You can use the bass increase control to make a little more low-end bump or you can also turn it on and off with the additional wired remote control.
Features:
The Kicker ZX300.1 features a CEA 2006 complaint where the power ratings are calculated according to the firm standards dictated by the Consumer Electronic Association (CEA). The unit also features a speaker level input or a high level input connection that allows you to use it with a source that does not have RCA preamp level output. Along with this, the unit also features a remote bass level control that allows you to adjust the output levels of the amplifier from anywhere in your vehicle. When you attach the remote bass level control to the mounting bracket it will have the dimension of W=2.204″, H=1.171″, D=2.253″ that includes the knob. There is also the KickEQ bass enhance circuit that offers a 12 dB signal increase at 40Hz."